How long does it take to fill the pool with water?

Depending on pool size, hose size, and water pressure. Remember to observe the fill-up process for several minutes to make sure that the pool is filling evenly and the water surface is level inside the pool.

How to preserve and maintain this inflatable pool?

1.Remove all accessories toys and pipes from the pool.

2.Open the drainage valve.

3.Open the inflating valve, fold the pool for faster deflation and drainage.

4.Fasten all the valves and expose the pool and its accessories to direct sunlight until it is complete.

5.Store in a clean and dry room.

6.Fix the small-sized leakage and breakage with the included fixing patches.

How does UV affect the materials used?

All PVC's degrade over prolonged exposure to excessive sunlight.

What is the best way to remove algae stains from the pool liner?

Empty the pool, use a soft brush, mild detergent, and water to remove algae stains from the pool liner. Thoroughly rinse and dry before refilling or storage.

What site is suitable to set up my Pool?

A level and stable surface are needed and all sharp objects must be removed. You can set up the above ground pool on grass, concrete platform, or pavement that is level and stable, free of sticks, stones, sharp objects, other foreign debris. A ground cloth is recommended. The pool should NOT be set up on sand or muddy ground that could make the pool shift.

Can grass grow through the ground cloth and/or pool liner?

Yes, in some cases some certain types of hardy grass such as Bermuda or St. Augustine can grow through the liner. So before setting up your pool, it is important that you should clear up the area of these types of hardy grasses. QPAU will not be held responsible for grasses that may grow through the ground cloth and/or pool liner, as this is not a manufacturing defect. A ground cloth or tarp may be help prevent this from occurring.

Can the pool be left in the garden year-round?

It depends on the weather in your area. It is not advisable to place the pool in a cold winter, which means the temperature is below 10 ° C (50 ° F) or the pool will be frozen to rupture.

How to prevent the pool bottom and inner wall become skid after used for some time?

Water changes may lead to skid on the pool bottom and inner wall. To reduce water changes can keep your pool covered when not in use, test the water regularly to ensure proper chemical balance, operate the pump for an adequate number of hours each day, keep the filter pump cartridge clean and replace the cartridge when needed.

Can I leave the site during filling the water?

No, you should stay there to observe the whole fill-up process.

1.You should make sure that the pool is filling evenly and the surface is level. If the pool is leaning to one side, you should check if the bottom of the pool was spread properly and the site has no slope, otherwise, you should change the site.

2. Frequently check the pool frame and make sure that all joints are fitted tightly and all vertical legs are vertical to the ground properly. OR, make sure that all bottom belts are stretched tightly and evenly, all of them are in one straight line.

3. When the water level reaches 1/2 capacity, please double check if all screws are screwed tightly and all tubes are inserted into plastic joints properly. Otherwise pool frame is not strong enough to hold the water.